Toyota Venza manuals

Toyota Venza: Inspection

INSPECTION

PROCEDURE

1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY


(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Switch free (Key removed)

10 kΩ or higher

1 - 2

Switch pushed (Key set)

Below 1 Ω

Text in Illustration

*1

Component without harness connected

(Unlock Warning Switch Assembly)

If the result is not as specified, replace the unlock warning switch assembly.

Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative ...

Other materials about Toyota Venza:

Transmitter ID1 Error (C2141/41-C2144/44)
DESCRIPTION The tire pressure warning valve and transmitter installed in each tire and wheel assembly measures the tire pressures. The measured values are transmitted as radio waves to the tire pressure warning antenna and receiver on the body and then se ...

Rear Light Assembly
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR LIGHT ASSEMBLY (a) Disconnect the connector from the rear light assembly. (b) Measu ...

Vehicle Speed Signal Malfunction (B2282)
DESCRIPTION The power management control ECU receives vehicle speed information using 2 methods. It receives a speed signal from the meter ECU. It also receives speed information from the meter ECU via CAN. If the information sent using these 2 methods is ...

© 2016-2026 Copyright www.tovenza.com

0.1617