Toyota Venza: Throttle Body

MIL Circuit

DESCRIPTION The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. By turning the ignition switch to ON, power is supplied to the MIL circuit, and the ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE UPPER BACK WINDOW PANEL TRIM (a) Disengage the 4 clips and 4 claws, and remove the upper back window panel trim. 2. REMOVE BACK DOOR PANEL TRIM ASSEMBLY ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure for the RH side and the LH side (See page ). 2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH HINT: Use the same procedure for the RH side and the LH side (See page ). ...