Toyota Venza: Roof Drip Side Finish Moulding

Rocker Panel Moulding

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT FENDER OUTSIDE MOULDING 2. REMOVE NO. 2 ROCKER PANEL MOULDING PROTECTOR 3. REMOVE REAR ROCKER PANEL MOU ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the engine immobiliser system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

System Description
SYSTEM DESCRIPTION 1. ENGINE IMMOBILISER SYSTEM DESCRIPTION The immobiliser system is a theft deterrent system that determines whether to disable starting of the SFI system based on a comparison of the key ID code and the vehicle pre-registered code. The ...

Installation
INSTALLATION PROCEDURE 1. INSTALL COOLER CONDENSER ASSEMBLY (a) Install the cooler condenser assembly with the 4 bolts. Torque: 6.0 N·m {61 kgf·cm, 53 in·lbf} HINT: If the condenser is replaced with a new one, add compressor oil t ...