Toyota Venza manuals

Toyota Venza: Removing a child restraint installed with a seat belt

Toyota Venza Owners Manual / Before driving / Safety information / Installing child restraints / Removing a child restraint installed with a seat belt


Press the buckle release button and fully retract the seat belt.

Installing child restraints using a seat belt (child restraint lock function belt)
 - Rear-facing -- Infant seat/convertible seat Place the child restraint system on the rear seat facing the rear of the vehicle. Run the seat belt through the child restraint system and ins ...

Child restraint systems with a top tether strap
Secure the child restraint using a seat belt or lower anchors, and do the following. ► Outside Adjust the head restraint to the upmost position. ► Center Lower the head restrain ...

Other materials about Toyota Venza:

Unlock Position Sensor Signal Circuit
DESCRIPTION The unlock position sensor is one of the components comprising the steering lock ECU (steering lock actuator assembly). The sensor switch contact closes when the steering lock is released. The steering lock release signal is then sent to the ...

Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE PEDAL ASSEMBLY (a) Install the parking brake pedal assembly with the 3 nuts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} (b) Connect t ...

Certification Ecu
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. N ...

© 2016-2026 Copyright www.tovenza.com

0.1414