Toyota Venza: Safety information

Theft prevention labels (U.S.A.)

These labels are attached to the vehicle to reduce vehicle theft by facilitating the tracing and recovery of parts from stolen vehicles. Do not remove under penalty of law. ...

Correct driving posture

Drive with a good posture as follows: 1. Sit upright and well back in the seat. 2. Adjust the position of the seat forward or backward to ensure the pedals can be reached and easily depressed to ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P4 ECU connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness si ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rea ...

Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
DESCRIPTION The driver side knee airbag squib circuit consists of the center airbag sensor assembly and driver side knee airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These ...