PROBLEM SYMPTOMS TABLE
HINT:
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
The SRS warning light goes off after the primary check, but then comes on. |
SRS Warning Light Remains ON |
|
|
With the ignition switch is turned ON, the SRS warning light sometimes comes on after approximately 6 seconds. |
SRS Warning Light Remains ON |
|
|
The SRS warning light always comes on even when DTC is not output. |
SRS Warning Light Remains ON |
|
|
With the ignition switch is turned ON, the SRS warning light does not come on. |
SRS Warning Light does not Come ON |
|
|
Although the SRS warning light operates normally, DTC or a normal system code is not displayed. |
TC and CG Terminal Circuit |
|
|
Although terminals TC and CG of DLC3 are not connected, a DTC or normal system code is displayed. |
TC and CG Terminal Circuit |
|
System Description
Terminals Of EcuSecurity Horn Assembly
Removal
REMOVAL
PROCEDURE
1. REMOVE SECURITY HORN ASSEMBLY
(a) Remove the bolt and disconnect the security horn assembly.
(b) Disconnect the connector and remove the security horn asse ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the LIN communication system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Body
General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) If necessary, tighten the bolts and nuts on the chassis parts listed below.
Front axle and suspension
Drivetrain
Rear axle and suspension ...