Toyota Venza manuals

Toyota Venza: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Automatic Glare-resistant EC Mirror

Symptom

Suspected Area

See page

Auto glare-resistant EC mirror does not operate

ECU-IG NO. 1 fuse

-

Inner rear view mirror


Wire harness or connector

-

Calibration
CALIBRATION 1. SELECT COMPASS DISPLAY MODE (a) The AUTO switch allows selection of the compass display. 2. PERFORM CALIBRATION (a) Because each vehicle has its own magnetic field, calibration shou ...

Inspection
INSPECTION PROCEDURE 1. INSPECT INNER REAR VIEW MIRROR ASSEMBLY (a) Inspect operation of the electrochromic inner mirror. (1) Connect a positive (+) lead from the battery to terminal 1 and a neg ...

Other materials about Toyota Venza:

Adjustment
ADJUSTMENT PROCEDURE 1. ADJUST STEERING WHEEL OFF CENTER (a) Inspect steering wheel off center. (1) Apply masking tape on the top center of the steering wheel and steering column upper cover. Text in Illustration *1 ...

Inspection
INSPECTION PROCEDURE 1. INSPECT PRELOAD (a) Using SST and a torque wrench, measure the preload of the backlash between the driven pinion and ring gear. SST: 09326-20011 Preload (at Starting): Item P ...

Meter Illumination is Always Dark
DESCRIPTION In this circuit, the meter CPU receives auto dimmer signals from the main body ECU (driver side junction block assembly) using the CAN communication system (CAN No. 1 Bus). When the meter CPU receives an auto dimmer signal, it dims the meter ...

© 2016-2026 Copyright www.tovenza.com

0.1216