Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Back Door Closer System


Power Back Door System

2. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT

(a) Perform zero point calibration and sensitivity check if any of the following conditions occur:

  • The occupant classification ECU is replaced.
  • Accessories (seatback tray and seat cover, etc.) are installed.
  • The front passenger seat is removed from the vehicle.
  • The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.
  • An occupant classification sensor collision detection DTC is output due to an accident or a collision.

NOTICE:

When an accident vehicle is brought into the workshop for repair, check the flatness of the body side that is equipped with the passenger seat. If the flatness is not within +/- 3.0 mm (0.118 in.), adjust it to the specified range.

3. EXPRESSIONS OF IGNITION SWITCH

The type of ignition switch used on this model differs according to the specifications of the vehicle.

The expressions listed in the table below are used in this section.

Expression

Switch Type

Ignition Switch (Position)

Engine Switch (Condition)

Ignition switch off

LOCK

Off

Ignition switch ON

ON

On (IG)

Ignition switch ACC

ACC

On (ACC)

Engine Start

START

Start

Occupant Classification System
...

Parts Location
PARTS LOCATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL SHIFT LEVER ASSEMBLY NOTICE: Check that the park/neutral position switch and the shift lever are in neutral. (a) Slide the slider of the transmission control cable in the direction indicated by the arrow an ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Audio and Visual System DTC Code Detection Item See page B1532 LVDS Signal Malfunction (from Extension Module) B1551 HD Radio ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK BATTERY CONDITION NOTICE: If the battery is weak or if the engine is difficult to start, perform the following procedure. (a) Check the battery for damage and deformation. If severe damage, deformation or leaka ...

© 2016-2026 Copyright www.tovenza.com

0.1717