Toyota Venza: Lumbar Support Adjuster Assembly

Installation

INSTALLATION PROCEDURE 1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER (a) Using a tacker, install the separate type front seatback heater to the end of the separate type front seatbac ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER MANAGEMENT CONTROL ECU (a) Disconnect the D42 and D43 connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Wiring Color Termi ...

Electrical Key Oscillator(for Rear Side)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE REAR BUMPER PLATE LH 2. REMOVE REAR BUMPER PLATE RH 3. REMOVE REAR BUMPER ASSEMBLY 4. REMOVE ELECTRICAL KEY ANTENNA (a) Disconnect the connector. ...

Cruise SET Indicator Light Circuit
DESCRIPTION The ECM detects a cruise control switch signal and sends it to the combination meter assembly through CAN. Then the SET indicator light comes on. The SET indicator light circuit uses CAN for communication. If there is a malfunct ...