Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT POWER SEAT LUMBAR SWITCH
|
(a) Install the front power seat lumbar switch with the 2 screws. |
|
.png)
2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY
.gif)
3. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
4. INSTALL RECLINING POWER SEAT SWITCH KNOB
5. INSTALL FRONT SEAT ASSEMBLY
6. INSTALL FRONT SEAT REAR INNER TRACK COVER
7. INSTALL FRONT SEAT REAR OUTER TRACK COVER
8. INSTALL FRONT SEAT HEADREST ASSEMBLY
9. INSPECT FRONT SEAT ASSEMBLY
10. INSPECT SRS WARNING LIGHT
(See page )
Inspection
INSPECTION
PROCEDURE
1. INSPECT DRIVER SIDE LUMBAR SWITCH
(a) Measure the resistance between the terminals when the switch is operated.
Standard Resistance:
Teste ...
Other materials about Toyota Venza:
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) Diagnostic System
When troubleshooting a vehicle with a diagnostic system, the only difference
from the usual troubleshooting procedure is connecting the Techstream to the vehicle
and reading various data output from ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (w/o Sliding Roof)
NOTICE:
If reusing the clips, do not remove the double-sided tape remaining
on the clips and where the clips will be installed on the body.
If installi ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Starting Control or Power Source
Control / Trouble Codes.
(e) Read t ...
0.1467