Toyota Venza: Power Seat Switch

Installation

INSTALLATION PROCEDURE 1. INSTALL FRONT POWER SEAT LUMBAR SWITCH (a) Install the front power seat lumbar switch with the 2 screws. 2. INST ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Headlight Dimmer Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (See page ) 2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY 3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY (a) Disconnect the con ...

Inspection
INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the intake side and exhaust side. PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. S ...

Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (driver side junction block assembly) stops for more than 10 seconds. DTC No. DTC Detection ...