CAUTION / NOTICE / HINT
HINT:
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
|
|
3. |
INSPECT BATTERY VOLTAGE |
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
|
4. |
INSPECT CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
|
Result |
Proceed to |
|---|---|
|
CAN communication system DTC is not output. |
A |
|
CAN communication system DTC is output. |
B |
| B | |
GO TO CAN COMMUNICATION SYSTEM |
|
|
5. |
CHECK FOR DTC* |
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| B | |
GO TO STEP 8 |
|
|
6. |
PROBLEM SYMPTOMS TABLE |
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table. |
A |
|
Fault is listed in Problem Symptoms Table. |
B |
| B | |
GO TO STEP 8 |
|
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test (See page
)
(b) Terminals of ECU (See page
)
|
|
8. |
ADJUST, REPAIR OR REPLACE |
|
|
9. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
Operation CheckPressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1) (P0748)
DESCRIPTION
Changing from 1st to 6th is performed by the TCM turning shift solenoid valves
SL1, SL2, SL3, SL4 and SL on and off. If an open or short circuit occurs in any
of the shift solenoid valves, the TCM controls the remaining normal shift solenoid
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
(a) Temporarily install the rea ...
Hood
Release the lock from the inside of the vehicle to open the hood.
Pull the hood release lever.
The hood will pop up slightly.
Lift the hood catch and lift the hood.
Hold the hood open by inserting the supporting rod into the slot.
CAUTION
- P ...