Toyota Venza: Fuel Injector

1ar-fe Fuel

...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Room Light
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE SPOT LIGHT ASSEMBLY (a) Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws to remove the 2 spot light lenses. Text in Illust ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Inspection
INSPECTION PROCEDURE 1. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the pad lining thickness. Text in Illustration *1 Ruler Standard thickness of a new pad: 10.0 mm (0.394 ...