Toyota Venza: Engine Coolant Temperature Sensor

Removal

REMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 3. REMOVE COOL AIR INTAKE ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not rotate the spiral cable with the battery connected and the ig ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Data of the system can be read from the Data Link Connector 3 (DLC3) of the vehicle. Therefore, when the system seems to be malfunctioning, use the Techstream to check for a malfunction and repair it. 2. CHECK DLC3 ( ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 ste ...