Toyota Venza: Brake Master Cylinder

Brake Line

Precaution PRECAUTION 1. TROUBLESHOOTING PRECAUTION NOTICE: Since the brake lines are critical safety related parts, be sure to disassemble and inspect the components if a brake flui ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL DOOR SIDE AIRBAG SENSOR (a) Check that the ignition switch is off. (b) C ...

Removal
REMOVAL PROCEDURE 1. REMOVE YAW RATE AND ACCELERATION SENSOR HINT: Refer to the instructions for Removal of the yaw rate and acceleration sensor (See page ). 2. REMOVE REAR NO. 2 AIR DUCT 3. REMOVE REAR NO. 1 AIR DUCT 4. REMOVE FRONT NO. 2 FLOO ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 REAR BUMPER REINFORCEMENT (a) Install the No. 1 rear bumper reinforcement with the 6 nuts. Torque: 68 N·m {693 kgf·cm, 50 ft·lbf} 2. INSTALL REAR BUMP ...