DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B1585 |
When any of the following conditions is met:
|
|
PROCEDURE
|
1. |
REPLACE USB DEVICE OR "iPod" |
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
(b) Turn the ignition switch off.
HINT:
When this DTC has been stored, it is necessary to turn the ignition switch off make it possible for the vehicle to recognize a new device when it is connected.
(c) Turn the ignition switch to ACC.
(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
).
|
|
2. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check that no DTCs are output.
OK:
No DTCs are output.
| OK | |
USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USBDEVICE OR "iPod" WAS DEFECTIVE |
| NG | |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
Sending Malfunction (Navigation to APGS) (U0073,U0100,U0140,U0155)
SD Card Communication Malfunction (B158C)Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. PRECAUTION (for HID Headlight)
(See page )
NOTICE:
After turning the ignition switch ...
SD Card Communication Malfunction (B158C)
DESCRIPTION
The navigation receiver assembly stores this DTC when the SD card (disc player
disc) cannot be mounted when inserted into the SD card (disc player disc) slot.
DTC No.
DTC Detection Condition
Trouble Area
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2A and 2F main body ECU (driver side junction block assembly)
connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
be ...