Toyota Venza manuals

Toyota Venza: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL PARKING PEDAL PAD

(a) Install the parking pedal pad to the parking brake pedal assembly.

2. INSTALL PARKING BRAKE SWITCH ASSEMBLY


3. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY


Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY 2. REMOVE PARKING BRAKE SWITCH ASSEMBLY 3. REMOVE PARKING PEDAL PAD (a) Remove the parking pedal pad from the parking brak ...

Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE PEDAL ASSEMBLY (a) Install the parking brake pedal assembly with the 3 nuts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK RADIATOR CAP SUB-ASSEMBLY (a) Measure the valve opening pressure. (1) If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring. (2) Check that r ...

Check CAN Bus Lines for Short Circuit
DESCRIPTION There may be a short circuit in the CAN bus main wire and/or CAN branch wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below 54 Ω. Symptom Trouble Area Resistance betwe ...

Lost Communication with Front Airbag Sensor LH (B1617/84,B1618/84)
DESCRIPTION The front airbag sensor LH circuit consists of the center airbag sensor assembly and front airbag sensor LH. The front airbag sensor LH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the ...

© 2016-2026 Copyright www.tovenza.com

0.1632