Toyota Venza: Positions for towing hitch receiver and hitch ball
1. Weight carrying ball position: 46.5 in. (1180 mm)
2. Hitch receiver pin hole position: 39.2 in. (996.5 mm)
Selecting trailer ball
Use the correct trailer ball for your application.
1. Trailer ball load rating
Matches or exceeds the gross trailer weight rating of the trailer.
2. Ball diameter
Matches the size of the trailer ...
Connecting trailer lights
Please consult your dealer when installing trailer lights, as incorrect installation
may cause damage to the vehicle’s lights. Please take care to comply with your state’s
laws when installing ...
Other materials about Toyota Venza:
Emission Control System
Parts Location
PARTS LOCATION
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FUEL CUT-OFF RPM
(a) Increase the engine speed to at least 3500 rpm.
(b) Use a sound scope to check for injector operating soun ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY
(a) Install the rear center seat outer belt assembly with the bolt and
nut.
Torque:
Bolt :
7.5 N·m {77 kgf·cm, 66 in·lbf}
Nut :
42 N·m {428 kgf·cm, ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure listed is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto any pai ...
0.1457