Toyota Venza manuals

Toyota Venza: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures of the front airbag sensor.

PROCEDURE

1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).


2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).


(b) Visually check the front airbag sensors for defects if the front bumper of the vehicle or the area around the bumper is damaged.

(1) The defects are as follows:

  • Cracks on the sensor housing
  • Dents on the sensor housing
  • Chips on the sensor housing
  • Cracks or other damage to the connector
  • Peeling of the label
  • Damage to the serial number

OK:

No defects are found.

HINT:

If any of the defects is found, replace the front airbag sensor with a new one.

3. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)

(a) When airbags have deployed as the result of a collision, be sure to replace all front airbag sensors in the damaged areas (anywhere in need of repair).

(b) Visually check the front airbag sensors in undamaged areas for defects.

(1) The defects are as follows:

  • Cracks on the sensor housing
  • Dents on the sensor housing
  • Chips on the sensor housing
  • Cracks or other damage to the connector
  • Peeling of the label
  • Damage to the serial number

OK:

No defects are found.

HINT:

If any of the defects is found or a front airbag sensor has detected a major collision, replace the front airbag sensor with a new one.

Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be su ...

Other materials about Toyota Venza:

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY (ENGINE ROOM JUNCTION BLOCK ASSEMBLY) (a) Remove the engine room junction block assembly from the engine room relay block (See page ). ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNETIC CLUTCH ASSEMBLY (a) Place the compressor and magnetic clutch in a vise. (b) Using SST, hold the magnetic clutch hub. SST: 09985-00270 (c) Remove the bolt, ...

© 2016-2026 Copyright www.tovenza.com

0.1641