Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL NAVIGATION RECEIVER ASSEMBLY

2. INSTALL NO. 2 RADIO RECEIVER BRACKET

(a) Install the No. 2 radio receiver bracket with the 4 screws.

Torque:

5.0 N·m {51 kgf·cm, 44 in·lbf}

3. INSTALL NO. 1 RADIO RECEIVER BRACKET

(a) Install the No. 1 radio receiver bracket with the 4 screws.

Torque:

5.0 N·m {51 kgf·cm, 44 in·lbf}

4. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)

5. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

(a) Engage the 4 claws.

(b) Install the instrument cluster center finish panel sub-assembly with the 4 screws.

6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

(a) Connect each connector.

(b) Engage the 2 clips.

(c) Install the navigation receiver assembly with bracket with the 4 bolts.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

7. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

8. INSTALL CONSOLE BOX SUB-ASSEMBLY

9. INSTALL POSITION INDICATOR HOUSING ASSEMBLY

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

11. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

12. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

14. INSTALL FRONT DOOR SCUFF PLATE RH

15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

16. INSTALL CONSOLE BOX ASSEMBLY

17. INSTALL NO. 2 CONSOLE BOX CARPET

18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).