Toyota Venza: Installation

Toyota Venza Service Manual / Seat / Power Seat Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL POWER SEAT SWITCH

(a) Install the power seat switch with the 3 screws.

(b) Connect the connector.

2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY

3. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

4. INSTALL RECLINING POWER SEAT SWITCH KNOB

5. INSTALL FRONT SEAT ASSEMBLY

6. INSTALL FRONT SEAT REAR INNER TRACK COVER

7. INSTALL FRONT SEAT REAR OUTER TRACK COVER

8. INSTALL FRONT SEAT HEADREST ASSEMBLY

9. INSPECT FRONT SEAT ASSEMBLY

10. INSPECT SRS WARNING LIGHT

(See page )

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (w/o Seat Position Memory System) (a) Measure the resistance between the terminals when each switch is operated. Standar ...

Rear Seat Assembly(for Lh Side)

...

Other materials about Toyota Venza:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

Accessory Meter
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL ACCESSORY METER ASSEMBLY (w/o Rear View Monitor System) (a) Connect the connector. (b) Engage the 2 clamps ...

Antenna Coil Open / Short (B2784)
DESCRIPTION The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU assembly. ...