Toyota Venza: Illumination for Panel Switch does not Come on with Tail Switch ON

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Illumination for Panel Switch does not Come on with Tail Switch ON

PROCEDURE

1.	CHECK VEHICLE SIGNAL (OPERATION CHECK)

(a) Enter the "Vehicle Signal Check Mode" screen.

Refer to Check Vehicle Signal in Operation Check (See page ).

(b) Check that the display changes between ON and OFF according to the light control switch operation.

OK:

Light Control Switch	Display
Tail or head	ON
Off	OFF

HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

REPLACE NAVIGATION RECEIVER ASSEMBLY

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

CD Sound Skips

PROCEDURE 1. CHECK CD (a) Check that the CD is not deformed or cracked. OK: No deformation or cracks on the CD. ...

Radio Broadcast cannot be Received or Poor Reception

PROCEDURE 1. CHECK NAVIGATION RECEIVER ASSEMBLY (a) Check the radio automatic station search function. (1) Check the radio automatic station search function by activ ...

Other materials about Toyota Venza:

Console Box Light
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) 3. REMOVE NO. 2 CONSOLE BOX CARPET 4. RE ...

Terminals Of Ecu
TERMINALS OF ECU 1. STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition D17-1 (GND) - Body ground ...

Control Module Communication Bus OFF (U0073/94,U0100/65,U0123/62,U0124/95,U0126/63)
DESCRIPTION The skid control ECU receives the signals from the ECM, steering angle sensor, and yaw rate and acceleration sensor via the CAN communication system. DTC Code DTC Detection Condition Trouble Area ...