Toyota Venza: Engine Hood Courtesy Switch Circuit

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Theft Deterrent System(w/o Smart Key System) / Engine Hood Courtesy Switch Circuit

DESCRIPTION

The security courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM

PROCEDURE

1.	INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)

(a) Remove the hood lock assembly (See page ).

(b) Disconnect the A7 security courtesy switch connector.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
1 - 2	Opened	Below 1 Ω
1 - 2	Locked	10 kΩ or higher

Text in Illustration

Component without harness connected

(Hood Lock Assembly (Security Courtesy Switch))

Opened

Locked

REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)

2.	CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
A7-2 - Body ground	Always	Below 1 Ω

Text in Illustration

*1	Front view of wire harness connector (to Security Courtesy Switch)

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.	CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SECURITY COURTESY SWITCH)

(a) Disconnect the D50 main body ECU (driver side junction block assembly) connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
D50-16 (HCTY) - A7-1	Always	Below 1 Ω
D50-16 (HCTY) - Body ground	Always	10 kΩ or higher

Text in Illustration

Front view of wire harness connector

(to Main Body ECU (Driver Side Junction Block Assembly))

Front view of wire harness connector

(to Security Courtesy Switch)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPAIR OR REPLACE HARNESS OR CONNECTOR

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Horn Circuit

DESCRIPTION When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (driver side junction block assembly) transmits a signal to cause the h ...

Other materials about Toyota Venza:

Operation Check
OPERATION CHECK 1. CHECK AUTO OPERATION NOTICE: Make sure that initialization is completed before inspection (See page ). HINT: When pressing the switch for 0.3 seconds or less, the roof glass moves but auto operation does not operate. (a) Turn the i ...

Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast. PROCEDURE 1 ...

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main body ECU (Driver side junction block assembly) Power back door ECU (Power back door motor unit) ...