Toyota Venza: Display does not Dim when Light Control Switch is Turned ON

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Display does not Dim when Light Control Switch is Turned ON

PROCEDURE

1.	CHECK IMAGE QUALITY SETTING

(a) Turn the light control switch to the tail or head position.

(b) Check that the daytime screen setting on the display adjustment screen is set to on.

Result	Proceed to
Daytime screen setting is set to on.	A
Daytime screen setting is set to off.	B

CHANGE DAYTIME SCREEN SETTING TO OFF

2.	CHECK VEHICLE SIGNAL (OPERATION CHECK)

(a) Enter the "Vehicle Signal Check Mode" screen.

Refer to Check Vehicle Signal in Operation Check (See page ).

(b) Check that the display changes between ON and OFF according to the light control switch operation.

OK:

Light Control Switch	Display
Tail or head	ON
Off	OFF

HINT:

The display is updated once per second. It is normal for the display to lag behind the actual switch operation.

REPLACE NAVIGATION RECEIVER ASSEMBLY

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Radio Broadcast cannot be Received or Poor Reception

PROCEDURE 1. CHECK NAVIGATION RECEIVER ASSEMBLY (a) Check the radio automatic station search function. (1) Check the radio automatic station search function by activ ...

Panel Switches do not Function

PROCEDURE 1. CHECK PANEL SWITCH (a) Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found. NG ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative ( ...

Evaporator Temperature Sensor Circuit (B1413/13)
DESCRIPTION The evaporator temperature sensor is installed on the evaporator in the air conditioning unit to detect the cooled air temperature that has passed through the evaporator and to control the air conditioning. It sends appropriate signals to the ...

Lost Communication with ECM / PCM "A" (U0100,U0129)
DESCRIPTION The power steering ECU receives signals from the ECM and the brake actuator assembly (skid control ECU) via the CAN communication system. DTC No. DTC Detection Condition Trouble Area U0100 ...