Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Rear View Monitor System

DTC Code

Detection Item

See page

C1622

Back Camera Disconnected


Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation ...

Other materials about Toyota Venza:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the camshaft, No. 2 camshaft, camshaft timing gear assembly, camshaft timing exhaust gear assembly or cylinder head sub-assembly (See page ). PROCED ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STIFFENING CRANKCASE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. (a) Using a plastic-faced hammer, tap in 2 new ring pins until they stop. Text in Illustration ...

Removal
REMOVAL PROCEDURE 1. REMOVE WHEEL ASSEMBLY 2. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) Remove the tire valve cap. NOTICE: Keep the removed tire valve cap. (b) Remove the valve core to release the air from the tire. NOTICE: Make sure that ...

© 2016-2026 Copyright www.tovenza.com

0.1181