Toyota Venza: Customize Parameters

Toyota Venza Service Manual / Seat Belt / Seat Belt Warning System / Customize Parameters

CUSTOMIZE PARAMETERS

1. CUSTOMIZE FUNCTION WITH TECHSTREAM

NOTICE:

Be sure to record the current settings before customizing.
These buzzers should be ON for safe driving. Perform these procedure only if it is necessary to set the buzzer OFF (disabled).

HINT:

The following items can be customized using the Techstream.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Combination Meter / Utility / Customize Setting.

(e) Select the setting by referring to the table below.

Combination Meter

Tester Display	Default	Content	Setting
Driver Side Seatbelt Warning Buzzer	ON	Function to sound the seat belt warning buzzer	ON/OFF
Front Passenger Side Seatbelt Warning Buzzer	ON	Function to sound the seat belt warning buzzer	ON/OFF

HINT:

This setting is only valid for the buzzer which sounds at 20 km/h (13 mph) or more.

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use these procedure to troubleshoot the seat belt warning system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO W ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota Venza:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" in the DTC chart. Inspect the fuses and relays before troub ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the vehicle's immobiliser system functions. Immobiliser system data and Diagnostic Trouble Code (DTC) can be read through the vehicle's Data Link Connector 3 (DLC3). I ...

Door Control Transmitter(w/ Smart Key System)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE TRANSMITTER BATTERY Inspection INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL TRANSMITTER (a) Inspect operation of the transmitter. (1) Remove the battery (lithium batt ...