Toyota Venza: Components

Transmission Control Cable

...

Removal

REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT (See page ) 2. REMOVE COOL AIR INTAKE DUCT SEAL 3. REMOVE INLET NO. 2 AIR CLEANER 4. REMOVE ...

Other materials about Toyota Venza:

Noise Occurs from Generator while Engine is Running
PROCEDURE 1. CHECK LOOSENESS OF V-RIBBED BELT (a) Check the tension of the belt by pushing it down with a finger. OK: The tension of the belt is enough. NG ADJUST V-RIBBED BELT ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Installation
INSTALLATION PROCEDURE 1. INSTALL DRIVE MONITOR SWITCH (a) Engage the 4 claws to install the driver monitor switch. 2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display ...