Toyota Venza: Components

Rear Airbag Sensor

...

On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the rear airbag sensor. PROCEDURE 1. INSPECT REAR AIRBAG SENSOR (VEHI ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY (a) Set the No. 1 center support bearing on the intermediate shaft as shown in the illustration. NOTICE: Make sure to install the bearing in the correct position. ...

Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEELS 2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH (a) Remove the 2 nuts and front stabilizer link assembly LH. HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold ...

Brake Warning Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. If any of the following is detected, the brake warning light remains on: The skid control ECU connector is disconnected from the skid control ECU. T ...