Toyota Venza manuals

Toyota Venza: Unmatched Encryption Code (B2794)

DESCRIPTION

This DTC is stored when a key with an incomplete key code is inserted into the ignition key cylinder.

DTC No.

DTC Detection Condition

Trouble Area

B2794

Key with incomplete key code is inserted.

Key

CAUTION / NOTICE / HINT

NOTICE:

If the key is replaced, register the key (See page ).


PROCEDURE

1.

REPLACE KEY

(a) Replace the key.


NEXT

2.

KEY REGISTRATION

(a) Register the key (See page ).



NEXT

END (KEY WAS DEFECTIVE)

Unmatched Key Code (B2795)
DESCRIPTION This DTC is stored when a key with a key code that has not been registered in the ECU is inserted into the ignition key cylinder. DTC No. DTC Detection Condition ...

Door Courtesy Switch Circuit
DESCRIPTION When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch assembly (for driver side) open/close condition, and en ...

Other materials about Toyota Venza:

Rear Sensor Communication Malfunction (C1AED)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the ECU, or when there is a malfunction in a rear sensor. DTC No. DTC Detection Condition Troubl ...

High Mounted Stop Light Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE CENTER STOP LIGHT ASSEMBLY (a) Using a short screwdriver, remove the 2 screws. (b) Disconnect the connector and remov ...

Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT: It is possible that a bulb is incorrectly installed, affecting headlight aim. Bulb installation should be considered prior to performing the adjustment procedure. PROCEDURE 1. PREPARE VEHICLE FOR HEADLIGHT AIM AD ...

© 2016-2026 Copyright www.tovenza.com

0.1633