Toyota Venza: Switching the display
1. “INFO” button
2. “SELECT RESET” button
To reset the functions below, press the “SELECT RESET” button.
• Average Fuel Economy
• Average Speed
• Trip Timer
3. “SETUP” button
Multi-information display (TFT type)
The multi-information display presents the driver with a variety of driving-related
data, including the clock and current outside temperature.
• Clock
Indicates and sets the time.
• Outside ...
Trip information
Display items can be switched by pressing the “INFO” button.
- Average Fuel Economy
Displays the average fuel consumption since the function was reset.
• The function can be reset by pr ...
Other materials about Toyota Venza:
Operation Check
OPERATION CHECK
1. CHECK POWER SEAT FUNCTION
(a) Check the basic functions.
(1) Operate the power seat switches and check to make sure each seat function
work:
Sliding
Front vertical (Driver side only)
Lumbar support
Lifter (Driver s ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2A, 2C and 2F main body ECU (driver side junction block assembly)
connectors.
(b) Measure the voltage and resistance according to the value(s) in the table ...
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION
Refer to DTC P0136 (See page ).
HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The
ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe
mode continues until the ignition switch is t ...
0.1508