DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
U0073 |
CAN bus connection error |
CAN communication system |
|
U0100 |
CAN reception error |
|
|
U0140 |
CAN reception error |
|
|
U0155 |
CAN reception error |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check that no DTCs are output.
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
GO TO CAN COMMUNICATION SYSTEM |
Voice Recognition Microphone Disconnected (B1579)
USB Media Malfunction (B1585)Clearance Warning ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the clearance warning ECU assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDUR ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
3. ...
Calibration
CALIBRATION
1. ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION
NOTICE:
Clear the rotation angle sensor calibration value, initialize the rotation angle
sensor, and calibrate the torque sensor zero point if any of the followin ...