Toyota Venza: Does not Play even after Bluetooth Audio Mode is Selected

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Does not Play even after Bluetooth Audio Mode is Selected

CAUTION / NOTICE / HINT

HINT:

Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in-vehicle device.

PROCEDURE

1.	CHECK OPERATION

(a) Check if the portable player operates normally.

OK:

The portable player operates normally.

MALFUNCTION IN PORTABLE PLAYER

2.	CHECK AUDIO SETTINGS

(a) In sound setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if the "Bluetooth" audio player plays normally on another "Bluetooth" audio compatible vehicle of the same model.

OK:

"Bluetooth" audio player plays normally.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

MALFUNCTION IN PORTABLE PLAYER

Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is of ...

Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bl ...

Other materials about Toyota Venza:

Side Turn Signal Light Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE OUTER MIRROR 2. REMOVE O ...

Transmission Wire(when Using The Engine Support Bridge)
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION WIRE (a) Coat the O-ring with ATF. (b) Coat the bolt with ATF. (c) Install the transmission ...

Removal
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOVE FR ...