Toyota Venza: Refrigerant

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR (a) Install the No. 1 cooler thermistor as shown in the illustration. Part Length ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET HINT: This is a method where a manifold gauge set is used to help locate the problem. (a) Read the manifold ...

Other materials about Toyota Venza:

Actuator Check
ACTUATOR CHECK 1. ACTUATOR CHECK (a) Start the engine and warm it up. (b) Perform the indicator check (See page ). (c) Press the "Recirculation/Fresh" switch to perform the actuator check. HINT: Be sure to perform the actuator check after ...

Customize Parameters
CUSTOMIZE PARAMETERS 1. CUSTOMIZE FUNCTION WITH TECHSTREAM NOTICE: Be sure to record the current settings before customizing. These buzzers should be ON for safe driving. Perform these procedure only if it is necessary to set the buzzer OFF ...

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY 3. RE ...