Toyota Venza: Rear Power Window Switch

Installation

INSTALLATION PROCEDURE 1. CLEAN QUARTER WINDOW ASSEMBLY (a) Clean the outer edges of the quarter window assembly with a non-residue solvent. NOTICE: Do not touch t ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSFER ASSEMBLY (a) Install the transfer assembly to the automatic transaxle assembly with 2 new bolts and the 6 nuts. Torque: 69 N·m {700 kgf·cm, 51 ft·lbf} NOTICE: Install the ...

Check CAN Bus Line for Short to GND
DESCRIPTION There may be a short circuit between the CAN bus main wire and GND when there is no resistance between terminals 6 (CANH) and 4 (CG) or 14 (CANL) and 4 (CG) of the DLC3. Symptom Trouble Area No resistanc ...

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195 (See page ). HINT: When any of these DTCs is stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...