Toyota Venza: Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

PROCEDURE

1.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the same model.

OK:

Track information is displayed normally.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

PORTABLE PLAYER IS NOT COMPATIBLE

Does not Play even after Bluetooth Audio Mode is Selected

CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 3. REMOVE COOL AIR INTAKE DUCT SEAL 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT ASSEMBLY (a) Disconnect the connector from the rear combination light assembly. (b) Measure the voltage according to the value(s) in ...

Light Sensor Circuit Malfunction (B1244)
DESCRIPTION The automatic light control sensor detects ambient light, converts it into an electrical signal, and outputs it to the main body ECU (driver side junction block assembly). The main body ECU (driver side junction block assembly) turns on or off ...