Toyota Venza: Noise Occurs or Sound Skips when Portable Player Plays

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT

HINT:

Perform this check with the portable player volume set at an appropriate level.
Make sure that there are no obstructions between the portable player and navigation receiver assembly that may block signals, and that the portable player and navigation receiver assembly are not excessively far apart.
Make sure that devices other than the navigation receiver assembly are not connected to the portable player.
Make sure that there is no interference from a wireless LAN, etc.

PROCEDURE

1.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the same problem does not occur in the sound heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.

OK:

The same problem does not occur in the sound heard from the speakers.

MALFUNCTION IN PORTABLE PLAYER

2.	REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.

OK:

The same problem does not occur in the sound heard from the speakers.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bl ...

Portable Player cannot be Connected Manually/Automatically

CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the navigation receiver assembly, eve ...

Other materials about Toyota Venza:

Light Control Switch Circuit
DESCRIPTION The main body ECU (driver side junction block assembly) receives the following switch information: Light control switch position off, tail, head or AUTO Dimmer switch position high, low or high flash (pass) Fog light switch posit ...

Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
DESCRIPTION The front passenger side squib circuit consists of the center airbag sensor assembly and front passenger airbag assembly. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs ...

System Description
SYSTEM DESCRIPTION 1. OUTLINE OF THEFT DETERRENT SYSTEM The theft deterrent system can be set by locking the doors using the transmitter or key, or by opening and closing the doors (for details, refer to Active Arming Mode or Passive Arming Mo ...