Toyota Venza: Installation

Toyota Venza Service Manual / Mf1a Transfer / 4wd / Awd / Transfer Assembly(when Not Using The Engine Support Bridge) / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSFER ASSEMBLY

(a) Install the transfer assembly to the transaxle assembly with 2 new bolts and the 6 nuts.

Torque:

69 N·m {700 kgf·cm, 51 ft·lbf}

NOTICE:

Install the transfer assembly to the transaxle assembly horizontally.
Do not touch the transfer assembly oil seals during installation.

2. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2GR-FE)

3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 1AR-FE)

4. INSTALL FLEXIBLE HOSE BRACKET SUB-ASSEMBLY (for 2GR-FE)

5. INSTALL WIRE HARNESS (for 2GR-FE)

6. INSTALL WIRE HARNESS (for 1AR-FE)

7. INSTALL TRANSFER STIFFENER PLATE RH (for 2GR-FE)

8. INSTALL TRANSFER STIFFENER PLATE RH (for 1AR-FE)

9. INSTALL MANIFOLD STAY (for 2GR-FE)

10. INSTALL STARTER ASSEMBLY (for 2GR-FE)

11. INSTALL STARTER ASSEMBLY (for 1AR-FE)

12. INSTALL FRONT FRAME ASSEMBLY (for 2GR-FE)

13. INSTALL FRONT FRAME ASSEMBLY (for 1AR-FE)

14. INSTALL REAR ENGINE MOUNTING INSULATOR ASSEMBLY (for 1AR-FE)

15. INSTALL STEERING LINK ASSEMBLY

16. INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY

17. INSTALL FRONT NO. 1 STABILIZER BRACKET LH

18. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as for the LH side.

19. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

See page for 2GR-FE

See page for 1AR-FE

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL TRANSFER DRIVEN PINION REAR BEARING (a) Using SST and a press, press the transfer driven pinion rear bearing (outer race) to the case. SST: 09950-6 ...

Transfer Assembly(when Using The Engine Support Bridge)

...

Other materials about Toyota Venza:

Operation Check
OPERATION CHECK 1. NOTICE WHEN CHECKING THE FOLLOWING (a) Power door lock/unlock function: This wireless door lock control function operates only when the following 3 conditions are met: (1) There is no key in the ignition key cylinder. (2) All doors ar ...

Removal
REMOVAL PROCEDURE 1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOVE FRONT WHEE ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new oil seal. NOTICE: Do not allow foreign matter to contact the lip of the oil seal. Do not allow MP grease to contact the dust seal. ...