Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 13 Speakers)

(a) Install the rear No. 2 speaker assembly with the 2 screws.


(b) Engage the clamp.

2. INSTALL REAR SPEAKER BRACKET (for 13 Speakers)

(a) Install the rear speaker bracket and rear door speaker grille sub-assembly with the 8 screws.


3. INSTALL REAR SPEAKER ASSEMBLY

(a) Install the rear speaker assembly with the 3 bolts.


(b) Connect the connector.

4. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP


5. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


6. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SPEAKER ASSEMBLY (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the spea ...

Satellite Radio Antenna
Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY (See page ) 2. REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY 3. REMOVE SATELL ...

Other materials about Toyota Venza:

Auxiliary boxes
►Type A (driver’s side instrument panel) Push down the knob. ►Type B (front console) Lift the lid. ►Type C (front console) Lift the lid. ►Type D (front passenger’s side instrument panel)  - Coin holder (type A) ...

Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS 1. NOTICE ABOUT VEHICLE CONDITION WHEN RAISING VEHICLE (a) The vehicle must be unloaded before jacking up or raising the vehicle. Never jack up or raise a heavily loaded vehicle. (b) When removing any heavy components li ...

Customize Parameters
CUSTOMIZE PARAMETERS 1. CUSTOMIZING FUNCTION WITH TECHSTREAM HINT: The items in the table below can be customized. NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to m ...

© 2016-2026 Copyright www.tovenza.com

0.1479