Toyota Venza: Installation

Toyota Venza Service Manual / Exterior Panels / Trim / Rear Door Belt Moulding / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING

(a) Engage the 5 claws to install the rear door belt moulding.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

3. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

4. INSTALL REAR DOOR GLASS RUN

5. INSTALL REAR DOOR WEATHERSTRIP

6. INSTALL REAR DOOR CHECK ASSEMBLY

7. INSTALL REAR DOOR SERVICE HOLE COVER

8. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

13. INITIALIZE POWER WINDOW CONTROL SYSTEM

(See page )

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Rear Door Window Frame Moulding

...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 3. REMOVE CO ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE LH 2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 4. REMOVE DECK BOARD ASSEMBLY 5. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 6. REMOVE DECK ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE NO. 2 ENGINE UNDER COVER 3. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 4. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 5. DRAIN ENGIN ...