Toyota Venza: Installation

Toyota Venza Service Manual / 1ar-fe Starting / Engine Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL ENGINE SWITCH

(a) Attach the 2 claws to install the engine switch.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

(a) Connect the connector.

(b) Engage the 4 claws to install the lower instrument panel finish panel assembly.

3. INSTALL INSTRUMENT CLUSTER FINISH PANEL

4. INSTALL UPPER STEERING COLUMN COVER

5. INSTALL LOWER STEERING COLUMN COVER

6. INSTALL CONSOLE BOX SUB-ASSEMBLY

7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

8. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

11. INSTALL FRONT DOOR SCUFF PLATE RH

12. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

14. INSTALL FRONT DOOR SCUFF PLATE LH

15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

16. INSTALL CONSOLE BOX ASSEMBLY

17. INSTALL NO. 2 CONSOLE BOX CARPET

18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Ignition Switch

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER 2. REMOVE UPPER STEERING COLUMN COVER 3. REMOVE IGNITION SWITCH (a) R ...

Other materials about Toyota Venza:

Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (w/o Smart Key System) (a) Measure the voltage according to the value(s) in the table below. Text in Illustration *1 Component with harness c ...

Power back door switch (vehicles with power back door)
Push the switch to close. Pressing the switch again while the power back door is closing will cause it to open again. However, the reverse operation cannot be performed for the first second after pressing the switch to close the door. The back door ca ...

Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE SWITCH ASSEMBLY (a) Install the parking brake switch assembly with the screw. Torque: 0.9 N·m {9 kgf·cm, 8 in·lbf} 2. INSTALL PARKING BRAKE ...