Toyota Venza manuals

Toyota Venza: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY

(a) Compress and extend the shock absorber rod 4 or more times.

Standard:

There is no abnormal resistance or sound and operation resistance is normal.

HINT:

If there is any abnormality, replace the front shock absorber with a new one.


Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT WHEE ...

Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY (a) Position the front shock absorber assembly level with the piston rod fully extended. Using a drill, make a hole in ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and the LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE REAR AXLE SHAFT NUT (for AWD) NOTICE: Perform th ...

Key Reminder Buzzer does not Sound
DESCRIPTION The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is in LOCK or ACC. The key reminder warning buzzer is activated when the main body ECU (driver side junction block assembly) sends an unlock w ...

Crankshaft Position Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH 2. REMOVE CRANKSHAFT POSITION SENSOR (a) Disconnect the sensor connector. (b) Remove the bolt and sensor. Inspection INSPECTION PROCEDURE ...

© 2016-2026 Copyright www.tovenza.com

0.1179