Toyota Venza: Fuel Pressure Regulator

Installation

INSTALLATION PROCEDURE 1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY (a) Apply a light coat of gasoline or spindle oil to a new O-ring. Text in Illustration * ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Cruise SET Indicator Light Circuit
DESCRIPTION The ECM detects a cruise control switch signal and sends it to the combination meter assembly through CAN. Then the SET indicator light comes on. The SET indicator light circuit uses CAN for communication. If there is a malfunct ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE NO. 2 ENGINE UNDER COVER 3. REMOVE WINDSHIELD WIPER MOTOR AND LINK (a) Remove the windshield wiper motor and link (See page ). 4. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 5. DRAIN ENGIN ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ...