Toyota Venza: Fail-safe Chart

Toyota Venza Service Manual / Cruise Control / Cruise Control System / Fail-safe Chart

FAIL-SAFE CHART

HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition	Auto Cancel Condition	Re-operation Condition
CRUISE main indicator light blinks	There is an open or short in the stop light switch assembly circuit There is a problem with the vehicle speed signal	Turn cruise control main switch on again
CRUISE main indicator light blinks	There is a problem with the input circuit of the stop light switch assembly There is a problem with the cancel circuit	Turn ignition switch off then on again Turn cruise control main switch on again
CRUISE main indicator light goes off	There is a problem with the throttle position sensor and motor (throttle with motor body assembly)	Turn cruise control main switch on again
CRUISE main indicator light remains on	Under the following conditions, the stored vehicle speed is maintained: Vehicle speed is lower than the low speed limit (approximately 40 km/h (25 mph)) while the vehicle is driven with the cruise control on VSC system operates	Push cruise control main switch to + RES
CRUISE main indicator light remains on	Vehicle speed is lower than the stored speed by approximately 16 km/h (10 mph) or more	Push cruise control main switch to - SET

Dtc Check / Clear

DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Cruise Control / ...

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

CD Sound Skips
PROCEDURE 1. CHECK CD (a) Check that the CD is not deformed or cracked. OK: No deformation or cracks on the CD NG END (CD IS FAULTY) ...

Engine Hood Courtesy Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT SECURITY COURTESY SWITCH (HOOD LOCK ASSEMBLY) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

Automatic anti-glare function
Responding to the level of brightness of the headlights of vehicles behind, the reflected light is automatically reduced. Changing automatic anti-glare function mode ON/OFF When the automatic anti-glare function is in ON mode, the indicator illuminates. ...