Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Data of the system can be read from the Data Link Connector 3 (DLC3) of the vehicle. Therefore, when the system seems to be malfunctioning, use the Techstream to check for a malfunction and repair it.

2. CHECK DLC3

(a) Check the DLC3 (See page ).


3. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Data List / Active Test
DATA LIST / ACTIVE TEST 1. USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Monitor the ECU data by following the prompts on the Techstream screen. HINT: The Techstream has a "Sn ...

Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
SYSTEM DESCRIPTION When the mirror adjust switch is operated, the main body ECU (driver side junction block assembly) detects the switch operation and sends the mirror adjust switch signal to the ...

Other materials about Toyota Venza:

Assist Map Number Mismatch (C1582)
DESCRIPTION When an incorrect ECM or brake actuator assembly (skid control ECU) is installed after the assist map has been recorded in the power steering ECU, then DTC C1582 is stored because the data does not match the vehicle specifications. ...

System Description
SYSTEM DESCRIPTION 1. NAVIGATION SYSTEM OUTLINE (a) Vehicle position tracking methods It is essential that the navigation system correctly tracks the current vehicle position and displays it on the map. There are 2 methods to track the current vehicle p ...

Precaution
PRECAUTION 1. PRECAUTION FOR DISCONNECTING BATTERY CABLE NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System See Procedure ...

© 2016-2026 Copyright www.tovenza.com

0.1349