Toyota Venza: Cylinder Head Gasket

Repair

REPAIR PROCEDURE 1. REPAIR INTAKE VALVE SEAT NOTICE: Repair the seat while checking the seating position. Keep the lip free of foreign matter. Take off the cutter gradually to make ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION HINT: The key has 2 codes: the key code (immobiliser code) and the wireless code. Both of these codes need to be registered. For the wireless code registration procedures, refer to Wireless Doo ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AIRBAG SENSOR (a) Check that the ignition switch is off. (b) Check ...

Replacement
REPLACEMENT PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head to approximately 80 to 100°C (176 to 212°F). (b) Place the cylinder head on wooden blocks. (c) Using SST and a hammer, tap out the valve guide bush. SST: 0 ...