Toyota Venza manuals

Toyota Venza: Check Mode Procedure

CHECK MODE PROCEDURE

1. CHECK MODE (SIGNAL CHECK): DTC CHECK

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / SRS Airbag / Utility / Signal Check, and proceed with checking using the Techstream.

NOTICE:

Select Signal Check screen on the Techstream to clear the output DTCs (both current and history).

HINT:

  • DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
  • Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.
Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK (USING SST CHECK WIRE) (a) Check the DTCs (Current trouble codes). (1) Turn the ignition switch to ON, and wait for approximately 60 seconds. (2) Using SST, connec ...

Data List / Active Test
DATA LIST / ACTIVE TEST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non ...

Other materials about Toyota Venza:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the vehicle's immobiliser system functions. Immobiliser system data and Diagnostic Trouble Code (DTC) can be read through the vehicle's Data Link Connector 3 (DLC3). I ...

Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) (P0741)
SYSTEM DESCRIPTION The TCM uses signals from the throttle position sensor, air-flow meter, turbine (input) speed sensor, intermediate (counter gear) speed sensor and crankshaft position sensor to help determine the engagement timing of the lock-up clutch. ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of steering gear assembly, be sure to place matchmarks before servicing. PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. SECUR ...

© 2016-2026 Copyright www.tovenza.com

0.1535