Toyota Venza: Voice is not Recognized

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Voice is not Recognized

PROCEDURE

1.	CHECK CONDITION

(a) Check if the system voice recognition level is low when recognizing a particular voice.

Result	Proceed to
System voice recognition level is low only for a particular voice.	A
System voice recognition level is low with any voice.	B

HINT:

System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Voice Guidance does not Function

PROCEDURE 1. CHECK VOICE GUIDANCE (a) Check that the voice guidance settings are not off. OK: Voice guidance settings are not off. NG CHANGE TH ...

Cellular Phone Inspection

PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR 2. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY 3. INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY (a) Engage the 5 claws. (b) Engage the guide and connect the wire harness. (c) Insta ...

Driver Side Door ECU Communication Stop (B2321)
DESCRIPTION This DTC is stored when LIN communication between the power window regulator motor assembly (for driver side) and main body ECU (driver side junction block assembly) stops for more than 10 seconds. DTC No. DTC Detection ...

Open in Front Passenger Side Electrical Antenna Circuit (B27A2)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and sends it to the door electrical key oscillator built into the front door outside handle assembly (for front passenger side) at 0.25-second intervals. To detect a k ...