Toyota Venza manuals

Toyota Venza: Trailer Tongue Weight

• A recommended tongue weight varies in accordance with the types of trailers or towing as described below.

• To ensure the recommended values shown below, the trailer must be loaded by referring to the following instructions.

• Tongue Weight The gross trailer weight should be distributed so that the tongue weight is 9 to 11%.

(Tongue weight / Gross trailer weight × 100 = 9 to 11%)

2GR-FE engine (Without towing package) and 1AR-FE engine


1. Gross trailer weight 2. Tongue weight

2GR-FE engine (With towing package)


If using a weight distributing hitch when towing, return the front axle to the same weight as before the trailer connection.

If front axle weight cannot be measured directly, measure the front fender height above the front axle before connection. Adjust weight distributing hitch torque until front fender is returned to the same height as before connection.

The gross trailer weight, gross axle weight and tongue weight can be measured with platform scales found at a highway weighing station, building supply company, trucking company, junk yard, etc.

GCWR, TWR and Unbraked TWR
Confirm that the gross trailer weight, gross combination weight, gross vehicle weight, gross axle weight and tongue weight are all within the limits.  - GCWR* and TWR* ► Vehicles withou ...

Hitch
Trailer hitch assemblies have different weight capacities. Toyota recommends the use of Toyota hitch/bracket for your vehicle. For details, contact your Toyota dealer. • If you wish to install ...

Other materials about Toyota Venza:

Power outlets
The power outlets can be used for 12V accessories that run on less than 10A. ►Console box ►Front passenger’s side instrument panel ►Luggage compartment  - The power outlets can be used when ►Vehicles with smart key sys ...

Replacing a flat tire
Chock the tires. Slightly loosen the wheel nuts (one turn). Turn the tire jack portion “A” by hand until the notch of the jack is in contact with the jack point. Raise the vehicle until the tire is slightly raised off the ground. Remove a ...

Rear Occupant Classification Sensor RH Collision Detection (B1788)
DESCRIPTION DTC B1788 is output when the occupant classification ECU receives a collision detection signal sent by the rear occupant classification sensor RH if an accident occurs. DTC B1788 is also output when the front seat assembly RH is subjected to ...

© 2016-2026 Copyright www.tovenza.com

0.1575