Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

  • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
  • When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the terminal is reconnected.

    System Name

    See Procedure

    Back Door Closer System


    Power Back Door System

2. IGNITION SWITCH EXPRESSIONS

(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Ignition Switch

(Position)

Engine Switch

(Condition)

Ignition Switch off

LOCK

Off (Lock)

Ignition Switch ACC

ACC

On (ACC)

Ignition Switch ON

ON

On (IG)

Engine Start

START

On (Start)

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

System Diagram
SYSTEM DIAGRAM ...

Other materials about Toyota Venza:

Starter Signal Circuit
DESCRIPTION 1. w/o Smart Key System While the engine is being cranked, current flows from terminal ST1 of the ignition switch assembly to the park/neutral position switch assembly and also flows to terminal STA of the ECM (STA Signal). 2. w/ Smart Key S ...

Lost Communication with AFS ECU (U0182)
DESCRIPTION DTC No. DTC Detection Condition Trouble Area U0182 No communication from the AFS ECU continues. AFS ECU branch wire or connector Power source circuit of AFS E ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Main Body DTC Code Detection Ite ...

© 2016-2026 Copyright www.tovenza.com

0.1142