Toyota Venza: Noise Occurs or Sound Skips when Portable Player Plays

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT

HINT:

Perform this check with the portable player volume set at an appropriate level.
Make sure that there are no obstructions between the portable player and the radio and display receiver assembly that may block signals, and that the portable player and the radio and display receiver assembly are not excessively far apart.
Make sure that devices other than the radio and display receiver assembly are not connected to the portable player.
Make sure that there is no interference from a wireless LAN, etc.

PROCEDURE

1.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the same problem does not occur in the sound heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.

OK:

The same problem does not occur in the sound heard from the speakers.

MALFUNCTION IN PORTABLE PLAYER

2.	REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.

OK:

The same problem does not occur in the sound heard from the speakers.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bl ...

Portable Player cannot be Connected Manually/Automatically

CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assemb ...

Other materials about Toyota Venza:

ECM Power Source Circuit
DESCRIPTION When the ignition switch is turned to ON, the battery voltage is applied to IGSW of the ECM. The output signal from the MREL terminal of the ECM causes a current to flow to the coil, closing the contact of the engine room junction block assemb ...

Lost Communication with Front Airbag Sensor LH (B1617/84,B1618/84)
DESCRIPTION The front airbag sensor LH circuit consists of the center airbag sensor assembly and front airbag sensor LH. The front airbag sensor LH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the ...

Inspection
INSPECTION PROCEDURE 1. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a) Apply positive (+) battery voltage to connector terminal 2 (B). NOTICE: Do not apply positive (+) battery voltage to any terminals other than terminal 2 ( ...